A bucket-mounted crusher built from threaded rod, scrap wood and printed parts.
Fruit Crusher by Open-Source-Imports
https://thediyjunky.com/@open-source-imports/fruit-crusher
Licence: CC-BY-SA-3.0
Adapted from: https://www.appropedia.org/Fruit_crusher
Original author: User:Haley alexis, User:Aeslater
Original licence: CC-BY-SA-3.0
A fruit crusher that mounts on a standard bucket. The source separates its bill of materials into things already on hand, things bought from a hardware store, and 3D printed pieces.
| Part | Size / spec | Qty | Unit cost |
|---|---|---|---|
| Bucket | Recommended 4 or 5 gallon | 1 bucket | — ^[Listed under materials already on hand] |
| Wood pieces | 13.5 inch long scrap wood | 2 pieces | — ^[Scrap wood can just be used] |
| Threaded rod | 1 foot long | 2 rods | — ^[From local hardware store] |
| Hex nuts | 1/4-20 inches | 20 nuts | — ^[From local hardware store] |
| Stop nuts | 1/4-20 inches | 10 nuts | — ^[From local hardware store] |
| Washers | 1/4 inch screw size | 12 washers | — ^[From local hardware store] |
| Hex cap screws | 1/4-20 x 3/4 inches | 4 screws | — ^[From local hardware store] |
| Hopper | 3D printed | 1 part | — |
Required total: ≥ $0.00
8 part(s) have no price recorded, so the total is a floor.